A Moai 130 Drip Arm.
V2 EDIT
I noticed I mis-measured a few items after I printed it. These have been fixed.

Not so simply designed in Tinkercad, but the result is relatively simple. When your print finishes, angling the build plate by transferring it to this arm will help drain the part and plate more completely.
The drip arm fits easily on the standard Z Arm and the Upgraded Z Arm so it should work with all Moai 130 series and variants.
I designed this off of an existing file which I have shared, but altered it drastically to have a smaller angle profile and shorter drop into the vat so I could use it on larger prints.
Included is a left and right favoring file so you can print it in the angle you prefer. This is designed to print directly on the build plate of your favorite SLA or MSLA printer with no supports.
I have tested steep angles used in this print on the Moai 130 specificially so I know that there are no angles that can't be printed as is on that printer.

https://youtu.be/ff6c-lV7Qa4

Peopoly

MOAI

No

No

0.75

90%

Peopoly Tough is the preferred resin. Siraya Tech Fast is a good alternative.