A camera holder for the back of the printer.

I was looking for a good way to timelapse and i used the back of the printer to mount the camera.

I have meshmixed the ball joint from the following thing:
https://www.thingiverse.com/thing:4721088

I use vslot M4 nuts to hold the bracket holder. This is the thing:
https://www.thingiverse.com/thing:1573410

The inner hole of the holders are 8,4 mm .
This is the diameter i wanted for my attachment.
This is the video from the first timelapse:
https://www.youtube.com/watch?v=6Lq5pqQvO1Y

the metalic spring is from an old led light.

for timelapse i use the front left option to stabilize.

Creality

Ender 3

No

No

0,2

50

I used 50% foe more robust parts.

I replaced the ir leds of the module with pirancha ones.
To do this you must have some basic welding skils.
You have to desolder the voltage regulator of the ir led board first and bridge the in-out of it.

If you want more info please leave a reply on the comments