Are you a dumb boy like me? Then you need this.

Anyone here spend many hours (days, months even) listening to your pod when they were much newer? I always had a giant rubber band around it to hold the extra amp or DAC. I wish they would come back today, but here we are in wireless headphone no headphone port madness hell.

My pod is modded with another headphone port on the top for a line out signal. This brick works with the Fiio amp either way up in the slot. For everyone without an extra port, you can use your 30 pin to 3.5mm adaptor. (I'm working on a right angle connector for the 30 pin so it fits in your hoodie pocket better).

The fit isn't very tight as I don't want the devices getting bashed up taking them in and out. Not that they need to come out often. You can leave them in the brick for safe keeping and charging.

Works only with the 5th gen classic. I also have a 4th gen version in a near finished state :)

To print, you just need the 30 pin port hole to be on the printer base. No supports needed. I wonder if this might work well in TPU...