This model is a simple Bench cookie. The key feature of this bench cookie, as far as I’m concerned, is the ability to add weight to it as desired. A standard printed bench cookie is too light, not very stable, and slides too easily on any surface (even one with a good coating). That’s why I created a version where you can add something (e.g., steel shot ;) ). For me, the hollow version weighs ~41g; after adding some steel shot, ~258g. Four of them add up to a solid ~1036g :) 

If you don’t want to add weight, I’ve included a solid version - use whichever you prefer :)

As I mentioned, I used shot to weigh down my bench cookie. Ultimately, I recommend pouring resin over it. First, it will be quieter; second, if it were to fall, without resin it might crack and scatter the contents all over the workshop. The resin will prevent that.

I used rubber cork for the lining. There’s also a printable template that helps you stick the lining on fairly evenly. Cut the rubber cork into a circle with a diameter of 66mm. I used contact cement, which I applied to both sides of the bench cookie and one side of the lining, then used the template to stick the lining on and pressed down as hard as I could.

You can also use a cool design by naregj91: Bench Cookie Dispenser for convenient storage of your bench cookies.