This is a cube to mount your 360 degree camera, in between the camera, use your selfie stick, then the cube, then, the parts below.

Cost for hardware currently at Home Depot: $ 10.20
1 - 3/4" x 24" PVC
2 - 3/4" end caps
1 - 1/4" 20 x 36" (you'll only need 5" of the rod) * see Optional below
1 - 1/4" 20 nylon lock nut (comes in a 3 pack)
2 - 1/4" washer (comes in a 12 pack)
Optional

• 1 - 1/4" 20 3/4" hex bolt (or, you can cut your own 1/4" 20 x 5" to insert though the 1/4" hole you'll drill through both end caps to insert the bolt to spin)

Build: Cut 5" of the rod or use the head of the 3/4" hex bolt to insert through the top hole. If using the bolt, after using a wrench to screw down into the threaded hole, cut off the hex head. File down the cut end for smooth connection to the selfie stick.
Use the nylon lock nut on the bottom of the 5" rod after inserting the rod down through the 1/4" holes you've made.
The washer goes between the top end cap and the and the nylon lock washer, leaving some space/play for the continuous spinning.

Please print in PEGT for strength.

Enjoy!