I stripped the screw on an light mount accessory for my bike, I did notice that it was used on a lot of different accessories for bikes, not sure if it's a standard or my imagination, but since i didn't find any thing in the website, I decided to design and upload it, I learned how to make threads in Sketch up, which is nice. God I really need to learn Fusion 360.

HIC Aurorar Reprap i3

Doesn't Matter

No

2

15

Print time for a single peace takes less than 5 mins, the outside diameter is 10mm (M10), seems to be standardized.

You can print the file with the pole, if you want to replace with a peace as close to the original as possible, or use the threaded one to screw it from the back, to make it harder to get off, or even without the screw, doesn't really matter to be honest.