This is a compact, snap-fit clip part designed to hold or support a tablet or display case.
The design originated as a precision sketch in Fusion 360 and was printed on a Prusa Core One in PLA.
The part locks securely into a base mount and supports adjustable angles while maintaining a clean and minimal aesthetic.

Fits tightly into the case slot shown in the pictures.

Tested with standard PLA and performs well under moderate load.

Can be scaled slightly if you need a tighter or looser fit.

Recommended Settings:

Layer Height: 0.2 mm

Infill: 20% gyroid or grid

Perimeters: 3

Supports: Not required if printed flat on the build plate

Print Orientation: Flat side down

Designed, printed, and tested on the Prusa Core One.