Stringing Retraction Test with numbers
jasper_rodriguez904
AI ile Benzer Model Bul
Baskı Profili(0)
Model Dosyası(0)
0
0
0
Yayınlandı:2020-09-16 07:18:46
0
0
000Açıklama
Etiketler
Model Kaynağı
Yorumlar(0)
These are small double-towers for your stringing test, the number on each part is for reference. DON'T FORGET to actually set the retraction value to the number of the part you're printing with that setting.
Best use "print separately" setting with per-model settings overrides, but that is not supported in newer CURA versions, so I had to use 3.5.1
Etiketler
Model Kaynağı
Orijinal Link: Detayları Gör
CC BY