This is a flickable disk that will easily fly farther than a bottle cap.

There are three different types of disks (all have the same shape).

-The thin version is not weighted at all

-The NoDime version has a slightly thicker top which uses infill for extra weight

-The dime version incorporates to insert a dime for maximum weight.

Personally i prefer the thinner version as it can be used indoors as the heavier ones could damage walls and such.

I would recommend using 5-10 percent infill for the disks (especially closer to 5 if using the TPU version).

Also when printing the TPU NoDime add a modifier in your slicer to bump up the infill for the first few layers to get the added weight.

*Any feedback on improvement would be greatly appreciated!

Enjoy :)