This is a wild adaptation of Adafruit's Raspberry Pi Zero Case. Access to SD cards and HDMI was removed, and replaced with a slot for an on/off switch. A camera flash mount is added as well.

This is intended to be a camera-mounted enclosure for both a Raspberry Pi and a Pimoroni Unicorn pHat, for use as a tally light.

Project details on how to build the tally light are available at https://github.com/deckerego/tally_pi

Notes:

M3D prints are generally low-resolution and can have fairly high variance - but the case is simple enough that it works even at a low resolution setting.

Front enclosure with a crystal filament as a diffuser - note this encloses most of the hardware.

Backplane - I left the rafts on because... they looked cool.