This is a simple ramp that can be temporarily placed around the marker light on a caravan to protect it whilst an awning is being slid onto the awning rail. This is particularly useful for caravans where the marker light is placed at the front corner of the sidewall immediately adjacent to the awning rail. On these caravans the awning (especially air awnings) can easily knock the light off and damage it.

I made a wooden version of this design which can be viewed on my YouTube channel here https://youtu.be/OExl7Fmzb8c .
The 3D Printed version is a much simpler design which can be made to higher tolerances and therefore sits more snuggly around the light.
Please note that this ramp design fits the older light designs that Bailey used until approx. 2023 when they changed to a more pointed, streamlined light fitting.

Printing is straightforward and should take approximately 6 hours depending on settings.

Creality

Ender 3 Pro

Doesn't Matter

No

low

20%

It's a solid lump so fairly basic print settings, placed with the large flat surface down.