Here come this time of the year, when all your employee (that answer you at “see you tomorrow” every evening with an “INSHALLAH”) are asking for their summer holidays. 

I feel you my dear managers friends, and i'm bringing you the solution : The INSHALLAH stamp!

You can print in all PLA, but i recomand TPU for the stamp it self, i tryed only with PLA but it gives some bad result because of the rigidity. With TPU by the way, you will need to clean the typography after print (because of stringing an nearows of the calygraphy) it is a little hard but nothing impossible (i had good result with a wire cuter and lighter).

For the handle i used 50% infill (or it may break at the screw base) 0.15mm.

For the stamp with TPU 15% infill 0.1mm. 

I brimed the print (mostly for the handle) and to make the tpu easyer to remove from the bed.

I've uploaded STL, 3mf, and Fusion360 files for thoses who want to modify the stamp ;-)