This is a mockup of a Waveshare 3.5 inch Touch Screen circuit board with ports, switches, mounts and flat cables included.  I updated my SOVOL Zero with the factory 5 inch touchscreen upgrade. And after spending a ton of time making a visually matching case to the original, I wound up not liking how large and out of it place it looked on such a very compact machine.  So, I went looking for a smaller version, similar in size to the screen on the Prusa machines I have.  

I landed on the Waveshare 3.5 inch TFT Touchscreen (part number X003QSE1PJ) with HDMI and USB-C on one side, and will be using this model to make a new enclosure for the Sovol, again sticking to the design language of the original screen enclosure for the printer.  

Amazon Link: Here or Here (As near as I can tell, these are the same, but have differing part numbers)

This was not intended to be printed, but to be used as a mock-up to size/position the board within the enclosure I am making for it.  But, after having such good luck with it, I figured I'd share some anyone else working on an enclosure for this touchscreen.

That said, I also made a much lower fidelity version (just placement of ports and switech) that CAN be printed and used as a physical mock-up for positioning of the screen relative to what you will be installing it in.  

I didn't have a ready supply of chip models, and really for the purposes of this, they really don't add much more than looks.  I mainly sourced my chip models from the following sources, both were the only examples I could find of circuit boards with chips modeled for 3D printers:

https://www.printables.com/model/973395-mplab-snap-microchip-pg164100

https://www.printables.com/model/1307275-mks-ips50-5-display-sovol-sv08-step-file-mockup

Many thanks to both designers for modeling HDMI, USB-C and IC components so nicely.

Enjoy!