This Desktop Microphone Arm Mount is a 3D-printable clamp designed to securely hold your microphone arm to a desk or table. Featuring a threaded screw and ergonomic knob, it allows for easy tightening and stability without damaging surfaces. Ideal for streamers, podcasters, and content creators, the mount offers a clean, low-profile design that fits most standard microphone arms. Designed for strength, ease of use, and minimal assembly, it’s a perfect addition to your home studio or recording setup.

Issue : I've Purchased a whole microphone desktop stand\Mount the base kept moving left and right and the only way to keep it standing is to NOT keep it close to my right hand\arm “especially when you have big arms” so it kept moving and not STAING IN ONE PLAC, me and my brother suffered from the same issue. 

Example of the issue : 



the solution was here to create an actual Microphone stand based on NATO manufacturing

 

Note : please make sure to measure the Microphone stand lip is 12 mm in width 
it could be Slandered size for these types of mic stands but it doesn't hurt to check it out before printing. 

 


Models Info Dimensions 

Base Mount 
X 65 mm
Y 96.0423 mm
Z 85.0556 mm

Screw Head 
X 60 mm
Y 60 mm
Z 15 mm

Screw 
X 43 mm
Y 43 mm
Z 77.2169 mm

 



NO AI INVOVED IN THE CREATION OF THIS MODEL 
 
PLEASE LIKE & SHARE & IF YOU PRINTED COMMENT