This is my first official design!

I wanted to mount my Alienware Alpha on the wall in my garage with the rest of my equipment, so I searched for a wall mount and couldn't find one I liked. The Alpha pulls air from the bottom and vents out the rear so I needed to leave the bottom exposed. I tossed a VESA mount on it (as close as I could get to a VESA Mount) With the 5mm Thick walls you could actually suspend this from under a desk if you wanted. I tested it and it seemed super sturdy.

Enjoy!

Print Settings

Printer:

Tronxy-XY3

Rafts:

**Supports:**

No

Resolution:

**Infill:**

50

Filament: Amazon Basics PLA White

Notes:

Category: Computer