Cane Grip
lucy_o'brien641
AI ile Benzer Model Bul
Baskı Profili(0)
Model Dosyası(0)
0
0
0
Yayınlandı:2026-04-06 05:33:54
0
0
000Açıklama
Etiketler
Model Kaynağı
Yorumlar(0)
The handle of my cane was damaged, so I decided to replace it after my dog destroyed the original. I printed the replacement using TPU without any supports. While there was some stringing because I skipped the supports, the final piece is still functional. This was also my first time experimenting with the Fuzzy Skin setting.
Version 2
Version 1 worked well, but it felt slightly off, so I made a few adjustments for version 2. I increased the overall length, reduced the size of the ends, and switched the infill pattern to honeycomb. When printing version 1, the only stringing issues were due to the lack of supports. However, with version 2, there was significant stringing on the inside, which I suspect was caused by a change in the nozzle temperature.
Etiketler
Model Kaynağı
Orijinal Link: Detayları Gör
CC BY