This is a simple remix of https://www.thingiverse.com/thing:4495778 to move the supports closer to the printer frame. The table I have my printer on is just barely big enough, so I had to move them in closer.

I was worried the increased leverage would make them more prone to failing, but have used them for many prints with no sign of issues.

I think I did make some mistake on the edit so they sit a little up from the frame, but nothing that should cause any issues.

Print Settings

Printer:

Sunlu S8

Rafts:

Supports:

No

Resolution:

Infill:

25%

Filament:

Sunlu PLA

White

Category: 3D Printer Accessories