Simple (10mm) Wrench + Hex Remover Set used for robotics. Includes....

1. 10MM hex wrench that is split into half for easy printability. 

• Build: Put the two halves together, and secure two 10-32 screws and locking nuts into the two holes to combine them. 

2. 10MM hex locking nut remover

• Build: Put the large piece with the handle, facing with the pin upwards. Take the gear, with the filleted/curved section facing into the pin. Attach the pin into the hole of the gear, and seal it all with the seal-fit cap (facing down, should be flat from the top).

To use #2, you will need to attach a screw with a 10MM hex, and use a flat head or large rectangular object to jam the gear, while using your preexisting phillips to untighten the screw out. 

*NOTE: You may need to flip all of the components to print properly, depending on your print slicer.