This is a vertical (tate) stand for the the Nintendo Switch 2. You can stand the Switch 2 on either side. That's it.

Printing

Print in the default orientation. Support is NOT necessary.

Adding Magnets

Adding magnets will help the stand stick to the Switch 2.

 

⛔⛔ WARNING: DO NOT try to pick up the console with the stand ⛔⛔

The magnets are not strong enough to hole the weight of the tablet!!!

 

10x3.5mm Magnet slots are provided at the bottom. Simply drop two D0.3"xH0.1" magnets into the slots.

I suggest doing so while the dock is connected to the Switch 2, so the magnets would end up in the correct pole orientation. If the magnet jumps out and sticks to the side, you can pick it up and flip it so it will go down properly.

Then, cut a piece of filament and fit it into the thinner slot so the magnet is kept away from the sticky tape and could move freely.

Finally, cut a piece of tape and seal the opening for the magnets.