Wanted to get my headset away from the desk and decided to draw up a headset holder to mount under the table, close to the edge for easy access.

Deliberately added a significant gap to make it easy to get the headset in and out.

Had some extra large flat head mounting screws which were short enough to not go all the way through the table, so designed the mount for those.

Print-wise i wanted to make a design that can be printed without support, and at the same time had a nice curve for distributed weight and less strain on the cushion inside the headset.

Not sure if this is useful unless you have the same screws for mounting, but decided to share the design anyway. Hope it can help someone tidy up their desk :)

The two holes are to allow access with a screwdriver.

Print it lying on the side with an added skirt, for maximum strength.