This is a wall-mounted bracket compatible with the VESA standard, suitable for most monitors of various weights and sizes.

It can be used in portrait mode
The inclination angle is about ±5 degrees
Rotation angle ±40 degrees
Safety load-bearing capacity: 20 pounds

I used PLA during the test, but I recommend using ABS or PETG, especially when the ambient temperature is above 25°C. This is very important because if the room temperature is too high or the load is too large, PLA will creep and deform over time.

However, the PLA has been in use for two years now, and it has performed well

Print settings

15–18% honeycomb filling
A four-story wall
0.15 storeys high
No support is needed
 

Parts list:
4 screws with a length of 1/4 inch and a width of 3 inches
4 screws with a length of 1/4 inch and a diameter of 3.5 inches
2 pieces of 5/16-inch conical screws, each 1.5 inches long
20 1/4-inch washers
2 pieces of 5/16-inch washers
1 1/2-inch threaded rod, 14 inches long
2 1/2-inch nylon lock nuts
5 1/4-inch nylon lock nuts
2 1/2-inch washers

1 kilogram of wire
4 days of printing time