Tried various CR Touch Mounts and ended up designing one to suit my needs:

Does not interfere or touch belt toggle on X Carriage
Does not hit frame when homing
Does not flex/move when probing so should get consistent probes
Works on most ender printers as its designed around the wheel mount bolt
Reinforced

To install,

1. Screw CR Touch to mount (2 x 10-12mm M3 bolts and nuts)
2. Loosen Wheel bolt and slip mount in place
3. Hold and tighten
4. Set Prob offset to X= -40 and Y= -10
5. Measure for Z offset but should be between -1.0 and -2.0

There were similar designs but all gave me trouble. This one is installed to a Ender 5 Pro and an Ender 3 Pro (Should fit Ender 5 Plus too and most other Ender models)

No

Yes

0.2 or 0.16

40%

Print in current orientation with supports (They are minimal).