This is a pre-assembled Skadis Mini Drawers very useful for those who wanted to store small bits like screws and stuffs for their workshop or workbench. The skadis panel however is modular by design and can be made quite large overtime

I decided to somewhat challenge myself to have a pre-assembled model where there are very minimal supports required. These can be stacked side by side or on top of each other.

The hook at the back is 4.5mm wide so this mini drawer will not scratch you expensive skadis panel, or will have a hard time inserting this into the panel including the 3d printed panels.

All tolerances are at least 0.5mm.

I made several design iteration and I think this is the best one I can go and I don't think I will ever going to adjust the design anymore.

MK3

Prusa i3

Doesn't Matter

Yes

0.2

Bridging infill angle 90'
Use support enforcer (for prusa slicer) with the included support models

You have to run an art knife's blade through the small gap to release the overhang from "gripping" the drawer/shell and the corners of the drawer at the front and at the back by cutting the small bridge support.

There should be almost no effort to pull out the drawer out once you ran the art knife's blade through the mentioned gap locations