I slightly changed FerriteGiant's excellent resistor storage solution in order to cut down on print time. These modified parts save about 24 hours of printing for the full set of 4 frames and 24 drawers! None of the important dimensions are different so the parts are interchangeable with the remix source. Note: The drawers are for 0.4mm nozzles

Simple frame (6 hrs / ~40m) - Saves 3 hours and ~20m of filament per frame.

Flat bottom drawer (3 hrs / ~17m) - 7 compartments, same as the original but without a rounded floor. (Holds slightly more parts with ~30 min print time reduction per drawer)

Single large drawer (2 hrs / ~11.5m) - 1 compartment. Fits a long single label.

Center label large drawer (2 hrs / ~11.5m) - 1 compartment. Fits the regular sized label.