UPDATE: Version two reduces the high of the center, it just wasn't needed, and reduces the thickness of the base as well. I overestimated what I would need for stability. This provides a faster print, less material used, and still gives exactly what it needs to not move around on your plywood surface.

Printing four of these will allow you to screw them into a nice piece of plywood, and keep your shiny new Phecda Laser Engraver from moving? Why?

So you can always find origin. The Phecda uses front left as it's point of origin. Sit your Phecda in the legs mounts, so it can't move around, and then use the Phecda to burn a mark into the lower corner, or a frame completely around the printable area, and you will always be able to align any work piece to the home origin spot with perfection.

Note: This is a prototype print at the moment. I'm looking for feedback and people who might be able to remix and improve the design.

I am including a 400mm x 400mm border, 4px thick, that I plan to test and make sure it will actually burn correctly to the print area to create the border frame.

No

No

12

There's not much here that requires a specific filament.