Summary

Display cover for Ender's 3 TFT35 E3 V3.0 from BIGTREETECH.

Not guarantee that it fits to Ender 3 Pro.

This is a remix from that thing.

What is changed:

• the main change: reduced the thickness of everything. The bottom is cutted from the inside, the walls - from the outside.
• removed the strange gaps on the left side of the Board mounts. The slicer doesn't see them, but Tinkercad does.
• remade the notch for the printer's foot. The last version is not tested, but should be right.
• added a hole for buzzer. It should be louder in open air.

The bottom turned out to be 0.8, the walls-1.2. And it saves 1/3 of the printing time (an hour of time with my settings) compared to the original thing.

Attention. The box turned out to be narrower than the metal frame for mounting the display, because the walls were reduced by 0.8mm. It is not critical for me, and it takes too long to make the walls thinner from the inside.