I was inspired to design a double-headed battle axe engraved with Celtic patterns. Putting it together was quite a challenge because it was too large to print in one go.

I suggest placing the outer surface of the axe head face down on the print bed for printing. Although there may be a slight gap between the blades, if the outer surface is facing up, the layering marks will be very obvious.

Make sure the support structure is in place. I use a tree-like support system.

You need to print four (4) axe heads, but I didn't make different printing boards

In the end, I painted it with colors to make it more distinctive.

Enjoy it to the fullest