This ishttps://www.printables.com/model/573567-stackable-kitchen-fruit-binsthe V2 version of it.

Model size:

11" long x 6" wide x 4" high (main part)

1.5" in height (pad)

The complete dimensions of the assembled storage box

The biggest problem with the previous version was that it required a lot of support. I rotated the square to fix this issue. Now, the only support needed is for the base, to which the main body/pad needs to be attached.

In addition, any sagging of the bottom base should be eliminated by the round support I added to the center, which should prevent the base and the main body

I hope everyone can make better use of this version. It will definitely consume less plastic.

**This model requires a 300mm^3 printing board.

Add supports to the print board for the bottom base and the detachable base. Flip the parts in the slicing software so that the legs of the two bases and the spacers are facing upwards. The main body or the spacers do not need supports.

I suggest adding a 0 mm spacing between the gasket and/or the main body part.

If you like it, please leave a comment! Thank you!