This mouse uses the internal electronics of a "VXE R1 SE" gaming mouse as its inner workings.

This project uses the circuit board of the "VXE R1 SE" mouse as the core

 

Extra hardware:

Additional hardware fittings:

 

(3x) m3*6 hex screw

(3x) M3*6 hexagonal screws

(3x) m3*4*4.2 heat-set inserts

(3x) m3*4*4.2 knurled nuts

 

(1x) Omron B3F-4055(12*12*7.3) tactile switch

(1x) Omron B3F-4055 (12*12*7.3) tactile switch

(2x) Omron B3F-6052 (6*6*7.3) tactile switch

(2x) Omron B3F-6052 (6*6*7.3) tactile switch

 

(Many times) Mouse Feet

(Any x) Mouse pad

 

 

Installation Tips:

Installation tips:

Cut away the protruding "flag-shaped" part from the 6*6 tactile switches.

Trim off the "flag-shaped" protrusion on the 6*6 touch switch as shown in the figure

 

Insert tactile switches as shown.

Install the switch as shown in the figure (it will be easier to install if you first solder the wires to the switch)

 

 

Add heat-set inserts to the body parts as shown.

Add knurled nuts to the three holes at the bottom of the back with a soldering iron

 

Cut away all the excess bits from the encoder as shown in the picture.

Install the encoder in the opposite direction compared to the original direction on the board. (The protruding blue ring should face the wheel)

After removing the encoder, cut off the excess metal parts

When installing the encoder, rotate it 180 degrees

 

 

Because the encoder has been turned around, exchange the wiring of the "A" and "B" pins (or the wheel will scroll the screen in the opposite direction).

Because the encoder has rotated 180 degrees, the wiring of the "A" and "B" pins needs to be swapped

Install the micro switches here.

Install the micro-switch at the position indicated by the basketball hoop

 

Align these 3 holes from the logic board to both the body and base parts, then tighten them with screws from the underside.

Align the three holes in the red circles on the baseboard, backboard, and circuit board and screw them in.

 

 

Miscellaneous:

 

2 sizes of side buttons were provided, install them as you please.

The side forward and backward buttons offer two heights, which can be installed and used according to your preferences