This is a Green Lantern energy ring, and its size is suitable for my middle finger

Please share your creation results. I'm really curious to see what it would look like if it were made with other printing materials.

It would be really cool to print it in two colors and use fluorescent material for the Green Lantern logo layer.

Printing materials used:Sunlu PLASilk Green

Remark:

I use Silk Green to print because it's the only green material I currently have. Other materials might be less sticky.

I found it important to increase the number of shells to 15, because too low filling density would cause the printer to vibrate too much, resulting in the print piece falling off the print bed. I also had to set the shell printing order to "from outside to inside".

After printing

Remove it from the printing bed. Put it on your finger. Take the oath.

Design process

I drew the Green Lantern logo and combined it with the blank ring of ZDP189.