INSTRUCTIONS:

• YOU NEED A CERTAIN NUMBER OF EACH MODEL, IT HAS A NUMBER IN ITS NAME EG. 2X_Bonecharm_keychain_ring    = PRINT 2 INSTANCES 
• IF THE STL FILES DO NOT HAVE A FULL BRIM, SINK THEM A FEW mm UNDER THE PRINTBED

ASSEMBLY.

1. GLUE 2 PARTS OF Bonecharm_keychain_ring UNTIL THE GLUE HARDENS
2. PUT THEM INTO THE SPOT ON THE Bonecharm_ring WHICH HAS A LITTLE GROOVE FOR IT
3. GLUE THE SECOND PART OF Bonecharm_ring ON TOP
4. ADD Bonecharm_cogwheel + Bonecharm_bone_hold
5. FINALLY GLUE Bonecharm_bone INTO THE Bonecharm_bone_hold

Its easy if you’re not completely stupid, hope you like the model.

You can print it in multiple colors like I did

Also if you want to wear it as a keychain, make it significantly smaller than my comically large instance (I know size is just a number but this makes it really annoying to wear(I don’t))