A case for setting up a stationary node indoors for the Heltec V3 board running on wall/PC power. My use case is for a Meshtastic Client_Base node connected to my pc, to help any nodes that might be deeper in my apartment get on the mesh, as well as messaging over serial via my PC.

Uses qty 4 M3x4x5 brass heat-set inserts in the bottom of the "heltec v3 base case top" part of the case, and qty 4 M3x6mm screws from under the "heltec v3 base case bottom" part of the case. I used button head screws, but pretty much any m3x6mm screw should work.

There might be room for a very small battery in there, but I haven't tried. YMMV.

Simple, but I hope you like it!