These are modified parts for the AtomRC Pan and Tilt module. The modules are not expensive and can be quickly swapped between craft. Broke a few parts of mine and decided to modify the design to specifically fit the Caddx Walksnail Moonlight camera and the common MG90S servo that is found on Amazon, etc. I've included the Fusion 360 file for your own editing/mods.

NOTES & Print Settings

• There is an M2 heat insert in the Tilt Servo Mount. You will have to transfer that. I provide pictures of the part, it's height, and installed on the modded Tilt Servo Mount.

• I used PETG for all parts, but PLA will work too.

• I did not use supports, but feel free to use them as needed for your print setup.

• 0.12 layer height

• 2 walls and 3 top and bottom layers

• 50% infill

• I Suggest using white colored filament to keep the camera cooler

Bambu Lab

Bambu P1S

No

No

0.12

50%

As stated in the primary description, be sure to install the M2 heat insert from the original Tilt servo mount.