toolbox for the Neptune printer.

use skirt to avoid issue with the tiny part in U (wich one is hanging the trail to the printer) or you will get some spagettiiiiiit!

infill doesnt realy matter at least 10% minimum i think is ok.

size for the costumisable slide : 2.25mm x 39.75mm x (length you want for the box)

i've printed the tiny on the side (you can see the little acceptable issue of overhang while printing the top part)

fusion360 files are there if you wanna make any change, any upgrade, anything wich can make it better in fact (and its not so difficult to..^^)

enjoy you new storing place!

ELEGOO Neptune

Doesn't Matter

No

0.2

10-15%

the full tool box (with holes) take average 3H30 to print
the tiny open tool box take something like 2h30