Made this to store my X-Acto #2 handle and my extra blades. I'm not sure exactly how many blades it can hold. but I'm guessing about 50.

Requires two magnets, dimensions are 8x2mm. I used a small dot of hot glue in the holes of the print to glue the magnets in. Havent had any trouble with this.

Oh, and getting the blades out can be tricky. I either use the magnet on the lid to pull them up or I use the tip of a blade to fish them out. Or if all else fails just dump them out. Just don't use your fingers.

No

No

0.2

33

I didn't print with any raft or brim, no supports, nothing out of the ordinary. But I did use ironing to get that ultra-smooth finish on the lid. Not necessary but I highly recommend.