1515 T-nut (for Voron0)
Electric Maze
AI ile Benzer Model Bul
Baskı Profili(0)
Model Dosyası(0)
0
0
0
Yayınlandı:2021-01-10 17:23:39
0
0
000Açıklama
Model Kaynağı
Yorumlar(0)
Summary
It is a great help during installation to prevent the nuts from moving. During the construction of Voron0, it comes in very handy with the screws of Pocketwatch, TopHat, Bed_Mount.
Hardware: M3 Square Nuts from Aliexpress (5.5mm x 5.5mm x 2mm)
The MakerBeam version is lower than the Chinese frame. I haven’t tried, but LDO frame can be similar to Chinese.
The flat version is needed for places like Voron0 T8_Nut_Block.
The hex nut is too high, it is difficult to print because only one or two layers get under the nut. (depending on the frame) But it also works.
Model Kaynağı
Orijinal Link: Detayları Gör
CC BY