Because the new battery does not quite fit the CX10 housing I thought up this alternative. You might want to add glue because it still comes apart on rough landings.

Tips:

• Add a bit of plastic (cut from a blister package) between battery and circuit board to prevent battery puncture
• the motor mounts have a notch (top ring) that fits in the PCB and a notch (botom ring with leg) that fits over the LED to prevent them from spinning.

Printed in PETG (Slightly flexible so it clamps on), not yet tested in PLA or ABS or ... - please let me know how that works if you try it.

It flies a lot better now the battery is centered.

Mendel90

No

No

0.2

doesn't matter / solid

Make sure nozzle is clean when it starts the first layer / add a skirt.

Adding a brim as well might help with bed adhesion and bottom layer shape. Because those things are tiny. Maybe print a little slower for proper cooling of the "leg" part, or print multiple at once for the same reason.

remove brim, make sure no globs of plastic interfere with fit on motor.