This print was made for a specific car waste container. The container is designed to be hung on a door pocket, but I do find this to be a convenient location, so I made this hanger. My first "stick-on" version (see below) worked (sort of), but the adhesive tape would not stay stuck. This version two attaches to the center console vinyl on the left of the passenger side (see photos). It requires additional hardware as follows :

• M3 x 12  (or M3 x 14) phillips head screws (qty 2)

• M3 hex nuts (qty 2)

Note that the screws act to clamp onto the vinyl, they do not require putting holes in the vinyl.

The waste container this was made for is sold as the following :

• ZONETECH Portable Hanging Mini Car Garbage Can – Classic Black Trash Container

• see also photos

Note : I have no connection to the company making this, or to the people selling it; I just happen to like this specific item.

As noted, the "stick-on" version of this hanger would just not stay stuck no matter what adhesive tape I used; you may have better luck. You can find that version here :

https://www.printables.com/model/1525324-hanger-for-car-waste-container-zonetech

Assembly and Use

Begin the assembly by inserting the two hex nuts into the hexagonal recesses in the BackHook part. The easiest way to do this is to thread the nut partially onto the screw, and use the screw to push the nut into the recess; the nuts should be a tight fit, so a light hammer tap may be useful.

Next, fit the hanger Hook part into the Base part (see photos for orientation). Unlike Version 1 of this model, there is no need to glue the Hook in place.

Mount the BackHook onto the vinyl by sliding it under the vinyl from the bottom; the vinyl has an interior lip which the BackHook fits onto. Screw the Hook/Base assembly onto the BackHook, tightening the screws firmly. Be sure to move the passenger seat all the way forward before fastening the hanger, so you can be sure it will not interfere with seat movement.

With the hanger in place, simply hang the trash container on the hook.

Print Instructions

Print in PETG using the 3mf files provided, otherwise :

Base and  BackHook :

Print flat side down (note support required).

• 0.2mm layer height

• 3 perimeters

• 15% grid infill

• support under internal "dovetail"

Hook :

Print on side for maximum strength.

• 0.2mm layer height

• 5 perimeters

• no infill

CAD

The OnShape 3D CAD files for this are here :

https://cad.onshape.com/documents/6d3ea379d59afa7379a306ec/w/0c7de63cac161ff6b31fd524/e/a186b62126f69b244f257bcd?renderMode=0&uiState=6949ac218b41453dd5b6de9d