Charging mobile stand designed to fit my Huawei P8 Lite and a random USB to Micro USB cable I had lying around.

Warning: This stand is specific to the shape of the micro USB connector I used and is probably not genericat all. I'm mainly uploading it in hope to get advice on how to improve it as I'm totally new to 3D printing and modelling :)

Print instructions

Category: Mobile Phone Print Settings

Printer: CR-10 Mini

Rafts: No

Supports: No

Resolution: 0.2mm

Infill: 20%

Notes:

Just used my basic settings. Make sure to print each half in the appropriate orientation, no need for any support.

Post-Printing

Print each half, place the micro-USB end of the cable between them and snap them together. Optionally use some glue to secure them. That's it!