Summary

Hey everyone! This is my take on a lifesize, DIY RPS-6 rocket launcher from the clone wars era. I intend on printing out the accessories listed here and epoxying them to appropriate PVC pipes. To complete this, you will need...

3" x 26" PVC pipe (x1)
3" PVC flat cap (x1)
1 1/2" x 21 1/2" PVC pipe (x1)
A suitable epoxy

The other accessories such as the tube bands are better suited to 8mm and 2-4mm EVA foam which I will cut and glue to the pipe as well.

Finally, for the scope, I intend to use an actual pocket monocular (probably a cheap one off of Amazon. And a 45 degree offset scope mount that I'll put on the targeting computer's picatinny rail. This is a WIP and may have some issues upon printing, make sure to report any of them here.

Last but not least, credit where credit is due!

While I didn't remix his model, I did view and measure it in 3D to scale it down to real life dimensions - David Short's "RPS-6".
https://sketchfab.com/3d-models/rps-6-a6e42985f2534875b513347ed0a41f6c

Go check out David Short's website while you're at it! He's got some awesome models. https://davidshort3266.artstation.com/

Additionally, I used SFE_Tim's "Picatinny Rail" for the rail on top of the targeting computer.
https://www.thingiverse.com/thing:23185