Summary

I was absolutely obsessed with masquerade masks a while back, I made these last yr but haven't printed them since last week.
I used a 0.4 mm nozzle & tree supports. I printed it standing up as is (I found printing them laying down had a weird affect when sanding).
I used 320 grit sand paper to sand it down.

I would recommend making a hole & adding straps to these to keep them on your face w/ smth stretchy, like polyester (which is super cheap, and you can buy it on amazon for $3.99 USD.)

Note, this was made using a Xbox Kinect scan of my face, so I'm not too sure how it'll fit on other face sizes.