• Filament Type: PLA

• Infill: 15%

• Layer Height: 0.16 mm

• Supports: Everywhere

Build Guide

Components used:

• ProMicro NRF52840 Development Board (Nice!Nano V2.0 compatible)

• SX1262 module

• FAKETEC PCB

• SMA to IPEX (IPX) pigtail cable (longer than 4 cm recommended to avoid sharp bending)

• GIZONT antenna

• 3-4 screws (used whatever was available)

Notes:

• Make sure the pigtail cable is not too short, as it can bend sharply and affect signal quality.

• Connect the ProMicro board to the FAKETEC PCB using pin headers (PLS), then trim the pins after soldering.

• The panels may be a bit fragile, but they allow light to pass through.

Once the power switch and BMS protection arrive, I will try to integrate them into the model.