This was inspired/remixed from Jhead's case. I didn't like having a screw in the front and the board screw holes were a bit off of center. I reinforced the front wall and labeled the audio ports and power (I could never remember which was "in" and "out"). I changed the case screws to go through the board screw holes and removed the holes in the top. Takes four 10mm m3 screws.

Print Settings

Printer Brand:

Prusa

Printer:

Rafts:

No

Supports:

Resolution:

.2

Infill:

Filament: Prusament PLA Whatever, I had some extra pink

Category: Audio