Cheese tube squeezer for all your squeezing needs. Prints in parts, some assembly required. 

• #1 is to insert the rod through the twist lid. 

• #2 Push the retainer down the rotator rod. Important: Arrange the retainer so that the tab on the rod is on the same side as the hole in the inner ring of the retainer. Also orient the retainer to that the sharp edge faces away from the lid/handle.

• #3 Push the retainer all the way in until it snaps in place.

• #3b I had to give it a smack to get it to set. But now the rod should be reasonably retained with the twist lid.

• #4 Insert cheese tube of your choice through the gap in the rotator rod.

• #5 Insert the whole tube and rotator assembly into the main body.

• #6 Rotate the twist lid to secure the whole thing in place. (It's also possible to assemble the whole thing and then insert the tube, but it's a little bit finnicky.)

And there you go. Squeeze your cheese on whatever you want.

This works best for metal tubes, since the metal itself keeps the new shape. Plastic toothpaste tubes for example wants to return to its previous shape.

Printed with a 0.6 nozzle at 0.15 layer height for the most part, except for the main body. This part will save a bit of time if its printed separately with variable layer height.