Introduction

I designed and printed a holder for my 8bit do controller that i wanted near my computer set up, also you can use this holder for other controllers.

I needed it to be:
   - Close but not visible
   - Easy to reach
 

Print Settings

Printed on: Sovol SV06

Slicer: Prusa Slicer

Material: ELEGOO Rapid PLA+  

Print Settings: 
   

     - Supports Everywhere (Honeycomb Pattern) 

      

      [Note: In the slicer i placed the marked face at the bottom to reduce printing time]

    - Infill: 30%

    - Layer Height: 0.2 mm 
      
      [Note It is not necessary to use 0.2 mm for the layer height]

 

Other 

    - Flathead Wood Screws (Diameter~2.72mm and Length~34mm~1-1/3") 

     [Note: This may vary depending on your desk, see that the model actually has a kind of                   washer or spacer i put  that in the model because i didn't have any screw that was shorter]
    

    - Other controllers i fit tested were: 
       Fit: 8bit do Ultimate C Wired, PS1, PS3, PS4, PS5, Nintendo Switch Pro                                        Controller.

       Don't Fit: Xbox 360, Xbox One, GameCube.

Conclusion

This is another model while practicing using OnShape to create my designs.
Please feel free to comment and give any feedback to the model.

(: