IKEA MALM bedside drawer caddys / organizers. Slightly different design for the left and right, and angled on one side of each to mate them up in your drawer. A very simple but effective way to keep your bedside drawers tidy ;-)

Each is made to fit in 1/4 area of the Ikea 'MALM' bedside drawers, so feel free to print 1, 2, 3 or 4 of them per bedside drawer. Personally I just printed a left and right to sit at the front of the drawer, and one for the rear, however you could orient them anyway around you like.

Made for MALM bedside drawers that measure 80 x 78cm (on the outside) Internal dimensions of drawer approx 316mm wide by 426mm deep. Picture of MALM drawers uploaded for reference

EDIT: 27 May 2020, added 2 more designs - a caddy with a single partition and a caddy with a long section, just in case these work better for your requirements. I have only printed the 'long' version which came out fine, but have not printed the 'single' partition version so if you do have issues post a comment and let me know. I also fixed up a couple of very minor (0.25mm) overhangs (barely noticeable if you've printed already)

Note: In the photo, the red and yellow caddys were my original design with a height of around 70mm. I found this to be unnecessarily high, so reduced the height of all caddys to around 60mm (which also reduces print time). The rear white caddy is printed at the 60mm height.

If you like it, click Like. If you make it, post your Make. If you have a problem with it, post a Comment and I will try and fix it.

Creality

Ender 5

Doesn't Matter

No

0.2

10%