Replacement O-ring for the steering limiter yoke sold by Woom for their children's bikes. My self-propelled destruction engine - ahem, toddler - ripped his in half, so we printed a new one.

The model isn't exactly complex - just an unusually-sized O-ring. I printed in Flexfill 98A with three perimeters and low infill, and it's substantially stiffer than the original. I'm honestly not sure that you need to print this in an elastomeric filament - it might be fine in a rigid, since the nylon strap that holds it onto the bike provides pretty substantial compliance. You will have to cut the stitching on the nylon strap to install this new ring.

Obviously, no warranty implied - use entirely at your own risk.

Comments much appreciated! Let me know if you'd like access to the original Onshape source.