These are extender brackets for a 11 1/8" X 6 7/8" (282.57mm x 174.62mm) glass bed plate. With these brackets and a larger glass bed, I was able to get quite a bit more room out of my Flashforge. Also after using a half spool of material getting the correct sizing right -_-

I had already used the original brackets for my CTC Pro with the same size glass, but the Creator pro has a thicker bed plate. I also had a slightly larger heat plate I had to account for, but it should still work on the default one. As shown in my 4th and 5th pictures, I was able to go from printing 2 base plates to 4 base plates at once, just by doing this upgrade. Doubling my efficiency. Please remember to use a shim for glass bed, and be careful about where your end stops are at when setting up your models for printing in your slicer. It can only go so much farther in the Y direction, be careful.

Shoutout to Maker111 for the original model, and EagleSeven for doing the measurements for the larger glass plate.

Flashforge

Doesn't Matter

Yes

0.2

20%

Print out and use the existing screws on the corner of your heated bed plate to attach the mounts. Model is aligned correctly, top 2 are for the top left and right corners, same for bottom.