This is a remix of the wundel's model, which was sadly not printable. I have optimized the model for 3D Printing, scaled it down, sliced it up in to pieces and separated the armor into different STLs.

The wings on the original model were a bit cumbersome, so I took the liberty of removing them and I think the model looks better for it. It will also print easier without the wings.

Perfect for D&D games, this demon is ready to tear out some souls!

Recommendations for printing are in "Instructions".

If you print, please post a picture! Especially if you paint it!

Tips:

Print all parts with support with the lowest layer height and generally finest settings you can get away with.

Print two of the 'head' files at the same time with the spikes pointing up, this will make it so that the spikes will have time to cool before the next layer.

Print 'torso' with the hands pointed upward.

Print 'legs' mostly on its back with the front of the demon pointing generally upward, this will reduce the amount of support material needed and aid in removing it.

Print two of the 'shoulder armor' files, orient so that the detailed part is not facing down.

Print one each of 'lower armor' and orient so that the top of the armor is not facing downward.

Enjoy!