Case for your Raspberry Pi Zero. This case requires no hardware and snap fits shut. The HDMI and USB are accessible with case on. Two different top covers available, one with access to the GPIO pins and can have a pHat attached, or one with teeth.

I am also including the Autodesk Fusion 360 Files so you can change the designs on the top and bottom case if you want.
http://a360.co/22ZLPZB - Face case with teeth
http://a360.co/22ZLYMy - Face case with GPIO access
http://a360.co/21eHW3u - Case with no designs for customization

The Pi Zero used in the design came from here - https://grabcad.com/library/raspberry-pi-zero-2

LulzBot

TAZ 5

No

200 Micron

zero

I printed this one with a 0.4mm nozzle with layer width of 0.4mm

Each half took about 30minutes to print for me and used around 9grams of filament